AP and NAV Display updates

AUTHORS

@@ -0,0 +1,18 @@
+McDonnell Douglas MD-11 for FlightGear, the free flight simulator
+
+MD-11 interior and exterior 3D models by Juuso Tapaninen (jormapaappa1235)
+FDMs, autoflight, fuel system, hydraulic system, pneumatic system, and cabin pressurization
+  system by John Williams (tikibar)
+Speed/Mach by Pitch controller, animation tuning, instruments, and systems fixed/updated by Joshua Davidson (it0uchpods)
+Sound pack by FL2070
+Custom GPWS sounds by Joshua Davidson
+Some systems adapted from other FG aircraft by Juuso Tapaninen
+
+Included liveries:
+Juuso Tapaninien created the liveries for Finnair, Finnair Cargo, FedEx, UPS, and KLM
+John Taillor created the liveries for Alitalia, Korean Air, Garuda Indonesia, Delta, Swiss, 
+  Aer Lingus, Lufthansa Cargo, and Japan Airlines.
+fsi created the livery for Varig Log.
+ACI created Centurion Cargo, McDonnell Douglas liveries.
+Jonathan Redpath (legoboyvdlp) created the livery for Viasa.
+

How To Autoflight 2.txt

@@ -0,0 +1,82 @@
+MD-11/MD-10-10F Autoflight 2:
+
+The autoflight system and this document are subject to change without notice. Please review after each update to the aircraft. -it0uchpods
+
+FIRST: Look at "How to Autopilot 1.png" to understand the knobs and switches of the autopilot!!!
+
+Engaging Autoflight:
+
+	NOTICE: Steps 1-3 may be done on the ground, before takeoff.
+
+	1) Set an IAS or Mach speed.
+
+	2) Verify that the AP Modes you want are active on the PFD. (HDG, NAV, V/S, etc)
+
+	3) Press AUTOFLIGHT.
+
+Disengaging Autoflight: 
+
+	NOTICE: A key for Autoflight disengage will be added.
+
+	NOTICE 2: Autothrust is still connected after performing this action, it will idle the thrust at 50ft, and disengage at 20ft.
+
+	1) Press the small Autoflight disengage on the left (captain) or right (first officer) side of the yoke.
+
+
+Disengaging Autothrust:
+
+	NOTICE: MD-11 Autothrust is not designed to be switched off. It will idle the thrust at 50ft, and disengage at 20ft.
+
+	1) Press the Emergency Autoflight disconnect, and the optionally push it back in.
+
+	OR
+
+	1) Press F11 or do Autopilot --> Autopilot Options and press A/T OFF
+
+
+Engaging Heading Hold (Assuming NAV is active):
+
+	1) Press the Heading knob.
+
+Engaging Heading Select (Assuming Heading Hold/NAV is active):
+
+	1) Middle Click the headinb knob.
+
+
+Engaging Vertical Speed Hold (Assuming Flight Level Change is active):
+
+	NOTICE: The mode will switch into ALT HOLD/FLCH automatically when the set altitude is achieved.
+
+	1) Adjust the V/S Dial, V/S is engaged automatically.
+
+
+Engaging Altitude Hold/Flight Level Change (Assuming Vertical Speed Hold is active):
+
+	1) Middle Click the Altitude Knob
+
+
+Engaging NAV (LNAV, Assuming Heading Hold is active):
+
+	NOTICE: If the route manager is not activated, NAV may not engage, or the aircraft may make endless circles.
+
+	1) Press the NAV Switch)
+
+
+Engaging Approach/Land Modes:
+
+	NOTICE: These modes do not become active immediatly, they are Armed, until the ILS is intercepted.
+
+	NOTICE 2: Autoland may not land the aircraft to well at this time.
+
+	NOTICE 3: This procedure will be slightly changed soon to be accurate to the real MD-11 Autoflight.
+
+	1) Press the APPR/LAND TWICE!
+
+	2) Verify that LOC ARMED and LAND ARMED Appear in the to of the PFD.
+
+
+Disengaging Approach/Land Modes:
+
+	1) Press the Heading Hold Knob.
+
+	2) Press the Altitude Hold Knob, and then set a vertical speed if desired.